Back

scatett

PROGRAMMABLE TEMPERATURE TRANSMITTER WITH PLASTIC JUNCTION BOX

Programmable Range

Temperature transmitter with plastic junction box; the housing is equipped with 2 cable gland for probe mounting and device’s probe supply. It is possible program the temperature range between 4-20 mA by a P.C. and with configuration kit

LinkedinEmail

Technical data

Electrical technical data
Supply voltage
8,5 ÷32 Vdc (polarity protected)
Accuracy
maximum value between ±0.2 °C and ±0.2% of range set
Response time of electronics section
<50 ms
Effect of temperature (*)
(*) devation from 20°C
Maximum value between ±0,3°C/25°C and ±0,3% of span/25°C
Permitted load
700 O @ 24 Vcc [RLO= (Valim. - 8,5) / 0,022]
Electronic board input
RTD Pt100 (a= 0,00385) 3 wire connection
PCB input range
-50 ÷800 °C
Sensor exciting current
~0,5 mA
Signal
4 ÷20 mA
Sensor failure signalling
upper scale (> 21.0 mA)
downscale (< 3.6 mA) action
Sensor short circuit signalling
Fixed at lower limit of range (< 3.6 mA)
Range configurations
It is possible set the device by EVOMINI+SET configuration kit (it is needed a PC with OS Windows).
Zero setting range
any value between -50°C and +50°C
Minimum span
50°C (if the zero point is one of these values: -40°C, -20°C, 0°C, 20°C, 40°C, the minimum span is 20°C, otherwise is 50°C)
Sensor error compensation
over 2 points (max 1% of span)
Factory default
range 0 ÷ 150°C / sensor break monitoring: > 21 mA (Upscale action)
Effect of power supply
Negligible
PCB operating temperature
-40 ÷80°C
EMC
According EN 61326
Sensor wire maximum resistance
20 ohm / wire
Effect of sensor wire
Negligible, if the wires all have the same resistance
Output signal type
4÷20 mA
Terminal electrical connection
connection head/box
Box probe version
with 3-pin input on terminal board
Fixing system
wall-mounting
Sensing part connection
head / connection box
Connection head / junction box
box 52 x 50 x H=35 mm wall mounting
Connection head / junction box material
PLASTIC
Ambient tightness degree (*)
(*) in accordance with IEC 60529
IP65/67
Cable gland dimension
Ø 5 ÷10 mm
Internal connection terminal type
4÷20 mA TRANSMITTER
Fixing accessories
wall mounting screws (self-tapping 3.5 for expansion plugs Ø6 mm) NOT SUPPLIED
Output
programmable 4-20 mA output

Drawing

PROGRAMMABLE TEMPERATURE TRANSMITTER WITH PLASTIC JUNCTION BOX
Certification documents
dowloadCE declaration of conformity (342.58kB)
Catalogs
dowloadSCAT_T_UK_R1 (1.19MB)
dowloadScata _Manual_IMB104_R1 (1.01MB)

Drawings Documents
dowloadMechanical Dimensions_Rear view (11.56kB)
dowloadMechanical Dimensions_Bottom view (34.62kB)
dowloadMechanical Dimensions_Side view (13.65kB)
dowloadMechanical Dimensions_View from above (17.84kB)

Video

No video